Toyota / Lexus / Scion · TNGA (E210) + Corolla Cross · 2020–2026
Corolla / Corolla Cross 2020–2026 engine ECU part numbers
2 engines, 3 ECU part-number families. Find the controller your car runs, then clone it onto a donor or adapt it remotely.
Engines and their ECUs
| Engine | Engine codes | ECU family | Model code |
|---|---|---|---|
| 1.8 / 2.0 4-cyl | 2ZR-FAE, M20A-FKS | Denso Gen3 (Renesas R7F7012xx, RH850) | |
| 1.8 / 2.0 hybrid | 2ZR-FXE, M20A-FXS | Denso Gen3 (Renesas R7F7012xx, RH850) |
Gen3 Denso: the unit is confirmed by label before you pay, and the on-car Techstream route is the fallback.
The model code is the family-level part of the label (for example 89661-06X91). A donor must match the full number, which we confirm against your VIN for free before you buy.
Clone the Corolla / Corolla Cross ECU — $350 flat
Mail your original and a donor with the same full part number. VIN, immobilizer data, coding and adaptations are copied across on the bench, typically within 24 hours of arrival. Factory immobilizer stays on.
Toyota / Lexus / Scion engine ECU cloneOn-car software step — remote Techstream, $250
Some cars still want an on-car step after a module swap — an ECU communication ID registration on a smart-key car, a calibration update, or a key registration. Plug a J2534 pass-thru interface into the car and we run the factory Techstream software on it from our bench — no dealer visit. The same session covers programming after any other Toyota or Lexus module replacement.
Book the Toyota / Lexus remote sessionFrequently asked questions
Which engine ECU does a 2020–2026 Corolla / Corolla Cross have?
It depends on the engine. The 1.8 / 2.0 4-cyl (2ZR-FAE, M20A-FKS) runs Denso Gen3 (Renesas R7F7012xx, RH850), model code 89661-12. The 1.8 / 2.0 hybrid (2ZR-FXE, M20A-FXS) runs Denso Gen3 (Renesas R7F7012xx, RH850), model code 89661-1A or 89661-0A. The label on your module settles it in seconds.
Can you clone the ECU on a Corolla / Corolla Cross TNGA (E210) + Corolla Cross?
Yes, with a label check first. This generation runs the newest controllers; some read and clone on the bench, some need the on-car route. Text us the label and VIN and we tell you which before you pay. The clone is $350 flat.
Will a cloned Corolla / Corolla Cross ECU need dealer adaptation?
Usually not — it leaves the bench carrying your VIN, immobilizer data, coding and adaptations. If the car still asks for an on-car step, we run it remotely with Techstream over your J2534 interface for $250.