Toyota / Lexus / Scion · GX 470 / 460 / 550; LX 470 / 570 / 600 · 1998–2026

Lexus GX / LX 1998–2026 engine ECU part numbers

2 engines, 1 ECU part-number family. Find the controller your car runs, then clone it onto a donor or adapt it remotely.

Routine bench clone on every engine listed

Engines and their ECUs

4.6 / 4.7 / 5.7 V8

1UR-FE, 2UZ-FE, 3UR-FE

Denso pre-CAN engine ECU / Denso Gen1 (NEC 76F00xx) / Denso Gen2 (D76F01xx / 02xx)

3.4 twin-turbo V6 (GX 550 / LX 600)

V35A-FTS

Denso Gen3 (Renesas R7F7012xx, RH850)

GX 550 and LX 600 are Gen3 — confirmed by label before payment.

The model code is the family-level part of the label (for example 89661-06X91). A donor must match the full number, which we confirm against your VIN for free before you buy.

Clone the Lexus GX / LX ECU — $350 flat

Mail your original and a donor with the same full part number. VIN, immobilizer data, coding and adaptations are copied across on the bench, typically within 24 hours of arrival. Factory immobilizer stays on.

Toyota / Lexus / Scion engine ECU clone

On-car software step — remote Techstream, $250

Some cars still want an on-car step after a module swap — an ECU communication ID registration on a smart-key car, a calibration update, or a key registration. Plug a J2534 pass-thru interface into the car and we run the factory Techstream software on it from our bench — no dealer visit. The same session covers programming after any other Toyota or Lexus module replacement.

Book the Toyota / Lexus remote session

Frequently asked questions

Which engine ECU does a 1998–2026 Lexus GX / LX have?

It depends on the engine. The 4.6 / 4.7 / 5.7 V8 (1UR-FE, 2UZ-FE, 3UR-FE) runs Denso pre-CAN engine ECU / Denso Gen1 (NEC 76F00xx) / Denso Gen2 (D76F01xx / 02xx), model code 89661-60. The 3.4 twin-turbo V6 (GX 550 / LX 600) (V35A-FTS) runs Denso Gen3 (Renesas R7F7012xx, RH850), model code 89661-60. The label on your module settles it in seconds.

Can you clone the ECU on a Lexus GX / LX GX 470 / 460 / 550; LX 470 / 570 / 600?

Yes — every engine ECU on this generation is a routine bench clone. Mail your original and a donor with the same full part number and we copy the VIN, immobilizer data, coding and adaptations across for $350 flat, typically within 24 hours of arrival.

Will a cloned Lexus GX / LX ECU need dealer adaptation?

Usually not — it leaves the bench carrying your VIN, immobilizer data, coding and adaptations. If the car still asks for an on-car step, we run it remotely with Techstream over your J2534 interface for $250.

← All Toyota / Lexus / Scion models and ECU part numbers