Toyota / Lexus / Scion · XA20 / XA30 / XA40 · 2001–2018
RAV4 2001–2018 engine ECU part numbers
2 engines, 1 ECU part-number family. Find the controller your car runs, then clone it onto a donor or adapt it remotely.
Engines and their ECUs
| Engine | Engine codes | ECU family | Model code |
|---|---|---|---|
| 2.0 / 2.4 / 2.5 4-cyl | 1AZ-FE, 2AZ-FE, 2AR-FE | Denso pre-CAN engine ECU → Denso Gen1 (NEC 76F00xx) → Denso Gen2 (D76F01xx / 02xx) | |
| 3.5 V6 (2006–2012) | 2GR-FE | Denso Gen1 (NEC 76F00xx) |
2.0 / 2.4 / 2.5 4-cyl
1AZ-FE, 2AZ-FE, 2AR-FE
Denso pre-CAN engine ECU → Denso Gen1 (NEC 76F00xx) → Denso Gen2 (D76F01xx / 02xx)
The model code is the family-level part of the label (for example 89661-06X91). A donor must match the full number, which we confirm against your VIN for free before you buy.
Clone the RAV4 ECU — $350 flat
Mail your original and a donor with the same full part number. VIN, immobilizer data, coding and adaptations are copied across on the bench, typically within 24 hours of arrival. Factory immobilizer stays on.
Toyota / Lexus / Scion engine ECU cloneOn-car software step — remote Techstream, $250
Some cars still want an on-car step after a module swap — an ECU communication ID registration on a smart-key car, a calibration update, or a key registration. Plug a J2534 pass-thru interface into the car and we run the factory Techstream software on it from our bench — no dealer visit. The same session covers programming after any other Toyota or Lexus module replacement.
Book the Toyota / Lexus remote sessionFrequently asked questions
Which engine ECU does a 2001–2018 RAV4 have?
It depends on the engine. The 2.0 / 2.4 / 2.5 4-cyl (1AZ-FE, 2AZ-FE, 2AR-FE) runs Denso pre-CAN engine ECU → Denso Gen1 (NEC 76F00xx) → Denso Gen2 (D76F01xx / 02xx), model code 89661-42. The 3.5 V6 (2006–2012) (2GR-FE) runs Denso Gen1 (NEC 76F00xx), model code 89661-42. The label on your module settles it in seconds.
Can you clone the ECU on a RAV4 XA20 / XA30 / XA40?
Yes — every engine ECU on this generation is a routine bench clone. Mail your original and a donor with the same full part number and we copy the VIN, immobilizer data, coding and adaptations across for $350 flat, typically within 24 hours of arrival.
Will a cloned RAV4 ECU need dealer adaptation?
Usually not — it leaves the bench carrying your VIN, immobilizer data, coding and adaptations. If the car still asks for an on-car step, we run it remotely with Techstream over your J2534 interface for $250.